https://scholars.lib.ntu.edu.tw/handle/123456789/111333
標題: | EXPERIMENTAL STUDY ON THE LOADING CHARACTERISTICS OF NEEDLEFELT FILTERS WITH MICROMETER-SIZED MONODISPERSE AEROSOLS | 作者: | CHEN, CHIH-CHIEH | 關鍵字: | PRESSURE-DROP;DUST CAKE;FILTRATION | 公開日期: | 2001 | 卷: | v.34 | 期: | n.3 | 起(迄)頁: | 262-273 | 來源出版物: | AEROSOL SCIENCE AND TECHNOLOGY | 摘要: | In this work, three types of needlefelt filters, made of Polyester (PE), Ryton Sulfar (RS), and Polyaramid (PA), were tested to investigate the aerosol loading characteristics of fabric filters when challenged with micrometer-sized monodisperse potassium sodium tartrate (PST) particles, A fibrous filter with packing density of 9 %, thickness of 0. 38 mm, and fiber diameter of 5.1 mum was included for comparison. A vibrating orifice monodisperse aerosol generator was used to produce three different sizes (5, 10, and 20 mum) of PST particles for aerosol loading experiment. An ultrasonic atomizing nozzle and a TSI constant output nebulizer were used to generate polydisperse PST particles for the aerosol penetration test. The aerosol penetration of submicrometer-sized particles through the filters was measured by using a Scanning Mobility Particle Sizer. An Aerodynamic Particle Sizer was used to measure the penetration fraction of aerosol particles larger than 0.8 mum The pressure drop across the filter was monitored by using pressure transducers, which were calibrated against an inclined manometer. Airflows of 5, 10, 20, and 30 cm/s were used to study the flow dependency. The aerosol penetration results showed that the particles larger than 3 mum did not penetrate the clean fabric filters tested in the present study. The loading curves (plots of pressure drop against sampling time) displayed three regions: an initial region of fast increase, a transition region, and a final linear region after the dust formation point. After the formation point of the dust cake, both fabric and fibrous filters shared the same slope (of the loading curves). The slope of different regions of the loading curves was determined by many factors, such as size of challenge aerosol, face velocity, surface treatment, and the compressibility of the dust cake forming on the filter, The method of final surface treatment was found to be critical to the performance of the fabric filters, In order to avoid the unnecessary rise in air resistance, the melting clumps formed during final surface treatment should be as thin and narrow as possible, just enough to support the filter bag cleaning. From the standpoint of filter quality and energy consumption, the low filtration velocity has to be adopted whenever possible, because high filtration velocity not only led to lower filter quality (in particular for submicrometer-sized particles) but also created dust cake of lower porosity, which caused an extra rise in pressure drop across the dust cake. |
URI: | http://ntur.lib.ntu.edu.tw//handle/246246/83893 |
顯示於: | 環境與職業健康科學研究所 |
在 IR 系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。