https://scholars.lib.ntu.edu.tw/handle/123456789/68305
標題: | Design of a Fuzzy Controller for the Adaptive control of WEDM Process | 作者: | Liao, Y.S. Woo, J.C. LiaoYS |
公開日期: | 2000 | 卷: | 40 | 期: | 15 | 起(迄)頁: | 2293-2307 | 來源出版物: | International Journal of Machine Tools and Manufacture | 摘要: | This paper addresses the design of a fuzzy controller for the control of the wire electrical discharge machining (WEDM) process. The power consumption and short circuit ratio are chosen as control parameters. Incorporated with pulse trains analysis and experience, fuzzy rules for the control of the WEDM process are formulated. A DSP-based on-line pulse monitoring system is developed, and the fuzzy control system is implemented on a PC-486. In the developed control system, a reference power level is specified beforehand, and feed is adjusted according to the computed actual machining power. Off time is regulated automatically so that short circuit ratio will not exceed a specific value. Fine tuning of feed and pulse off-time is conducted if the variation in the average ignition delay time is too large. Experiments show that the developed control strategy results in very satisfactory transient and steady state responses as compared with a conventional control scheme. |
URI: | http://ntur.lib.ntu.edu.tw//handle/246246/87010 https://www.scopus.com/inward/record.uri?eid=2-s2.0-0343353913&doi=10.1016%2fS0890-6955%2800%2900036-5&partnerID=40&md5=c4277005e2865bb51754781f1a28a75d |
ISSN: | 08906955 | SDG/關鍵字: | Control system analysis; Control system synthesis; Fuzzy control; Process control; Wire electrical discharge machining (WEDM) process; Machining |
顯示於: | 機械工程學系 |
在 IR 系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。